Hook Strip Flat Screen
Hook strip flat screens are the series applied most widely at present. These products can
be fit for all kinds of shale shakers that use the hook strip flat screen. This screen panel is constructed with two or three stainless
steel layers bonded to a steel support plank. Accessory rubber
plugs may be inserted to the rips or tears of the screen. By doing
this, we can cut down time and the production cost. We can supply hook strip flat screens with mesh sizes ranging from 12 to 275.
Features of HOOK STRIPE FLAT PLATE SCREEN:
- Different layers with different density. To arrange these layers
reasonably and exactly, the screening effect will become more and
better. Screen with different mesh counts with suitable opening
sizes of the backing plate. Doing so, our products will obtain the
largest effective area under the condition of enough strength.
- The bottom layer with low mesh counts has coarse wire and can be
tight bonded to the backing to make up one block. So the strength
of whole screen mesh get up and the useful life is increased.
- The mesh, divided into many independent small units by grids of the
backing plate, can prevent rigs of tears from spreading overmuch.
Accessory prepared rubber stoppers can be used to repair damages.
By doing so, the operator can cut down the stop time and reduce the
|Screen Model||Range of Mesh||Dimension (Length × Width)||Brand & Model Of Shaker||Weight (Kg)|
|PDHF-1||16–325||903 × 1155 mm||BEM-3||5.6|
|PDHF-2||16–325||1212 × 1141 mm||ALS-11||9|
|PDHF-3||16–325||697 × 1050 mm||FLC500 Series||6|
|PDHF-4||16–325||697 × 1053 mm||FLC2000||4.2|
|PDHF-5||16–325||697 × 846 mm||FLC313M||4|
|PDHF-6||16–325||915 × 1150 mm||LCM-20||8.6|
|PDHF-7||16–325||720 × 1220 mm||KTL48 Series||5.6|
|PDHF-8||16–250||700 × 1165 mm||S250||4.6|
|PDHF-9||16–250||1186 × 1280 mm||ZX60||9.2|